Stereo Splitter (THRU) & Mono mixer with Pan control
With this device you can mix two signals into a single output and still be able to use the original signals since they pass unchanges through the splitter to the respective outputs.
e.g.: You can mix the L & R channels of a stereo signal down to mono and still be able to use the original stereo signal.
e.g.: You can mix the L & R channels of a stereo signal down to mono and still be able to use the original stereo signal.
 |
| signal flow chart |
A Pan knob has been added to the mixer in order to help you set the desired mix level of the two signals.
▹ Voltage Required: DC 9-24 Volt [Do not exceed recommended voltage! It may damage the circuit.]
▹ Polarity: Negative tip
▹ Max Current draw: 10mA (@ 9V)
▹ Input Impedance: 1MΩ
▹ Output Impedance: 100Ω
▹ All jacks are TS
▹ Voltage Required: DC 9-24 Volt [Do not exceed recommended voltage! It may damage the circuit.]
▹ Polarity: Negative tip
▹ Max Current draw: 10mA (@ 9V)
▹ Input Impedance: 1MΩ
▹ Output Impedance: 100Ω
▹ All jacks are TS
