This is the latest & improved version of our classic Stereo Mixer. (Check our 4ch mixer here)
The dpFX Stereo Effects Mixer is a parallel mixer designed for stereo pedals & pedalboards and is also compatible with line level signals. It can be used as a summing box that can take up to 3 stereo signals and combine them into a single stereo output.
It features high-impedance TRS inputs (buffered with JFET op amps) that can be driven by instruments (guitar, bass etc) or line level signals as well. It makes use of low distortion, low noise op amps and each input has a volume knob that goes from mute, up to +6dB gain.
It features high-impedance TRS inputs (buffered with JFET op amps) that can be driven by instruments (guitar, bass etc) or line level signals as well. It makes use of low distortion, low noise op amps and each input has a volume knob that goes from mute, up to +6dB gain.
The output impedance is very low ensuring the best interconnectivity with the rest of your gear.
Output and all inputs are stereo, suitable for TRS Jacks (6.35mm) but the mixer can also be used in mono-mode simply by pluging mono-jacks in all inputs & the output. You can also mix stereo and mono inputs as long as you use a stereo output.
You can also mix stereo and mono inputs as long as you use a stereo
output. Just make sure that for the mono signal you use a TS 1/4" to TRS 1/4" cable that ties
the Tip of the TS into both the Tip and Ring of the TRS in order to feed
the mono signal in both L & R channels
NOTE: if you use standard TS cable for the mono signal it will only appear on the L-left channel of the stereo output).
▹ Voltage required: DC 9-24 Volt (higher voltage gives you more headroom)
[Do not exceed recommended voltage! It may damage the circuit.]
▹ Current draw: 28mA @ 9V
▹ Input impedance: 10MΩ
▹ Output impedance: 100Ω
[Do not exceed recommended voltage! It may damage the circuit.]
▹ Current draw: 28mA @ 9V
▹ Input impedance: 10MΩ
▹ Output impedance: 100Ω
▹ The mixer is always ON when power is connected (external LED is lit when ON)
▹ Enclosure dimensions: 122 x 66 x 39.5 mm [4.8 x 2.6 x 1.57 in]
▹ Weight: 265gr
Possible use:
- Run Stereo Effects in parallel.
- Connect multiple instruments to one amp
- Combine parallel effects chains.
- Send three stereo channels into one output.
- Run Stereo Effects in parallel.
- Connect multiple instruments to one amp
- Combine parallel effects chains.
- Send three stereo channels into one output.
