Custom Tails Bypass Looper (active) with remote On/Off
Tails Bypass Looper offers you the ability too add tails (aka trails) to any of your time-based effects. Which means that you can bypass your delay and still be able to hear the repeats fading. The looper is active and has unity gain (no volume loss) with buffered inputs/outputs in order to maintain your tone intact.
In this custom version the switching is done remotely with the help of any latching switcher (e.g. Boss MS3 or similar) that should be connected to the TS jack marked as “Remote ON/OFF”
Just connect your time-based effect to the Send/Return loop and with your switcher you can bypass it anytime you see fit, keeping the tails in the mix along with your dry signal.
specifications:
▹ Input impedance: IN = 360kΩ, RTN = 200kΩ
▹ Output impedance: SND/OUT: less than 100Ω
▹ Voltage Required: DC 9 Volt
▹ Polarity: Negative tip
▹ Max Current draw: ~7mA
In this custom version the switching is done remotely with the help of any latching switcher (e.g. Boss MS3 or similar) that should be connected to the TS jack marked as “Remote ON/OFF”
Just connect your time-based effect to the Send/Return loop and with your switcher you can bypass it anytime you see fit, keeping the tails in the mix along with your dry signal.
specifications:
▹ Input impedance: IN = 360kΩ, RTN = 200kΩ
▹ Output impedance: SND/OUT: less than 100Ω
▹ Voltage Required: DC 9 Volt
▹ Polarity: Negative tip
▹ Max Current draw: ~7mA
