Equipped with phase reverse switches for the return signals of each loop and pan control between the two loops.
→ The special feature of this blender is that it offers a dry blend ONLY when one loop is not used at all (check below for more details).
You can mix 2 different loops (A, B) in parallel and pan between them, choosing the amount of blend that fits your needs through the PAN knob. A separate phase reverse switch for each loop allows you to avoid any phasing problems when using pedals that flip the phase.
Details and specifications:
▹ When A-loop is not in use: The SNDA is routed directly to RTNA so that you get the dry signal blended with the signal from B-loop. (The same applies when loop B is not in use). With the PAN knob you can select the blend ratio between the Dry and Wet signal. Bassists can use this feature in order to use guitar pedals without loosing their low-end.
▹ The footswitch completely bypasses the circuit. (true bypass)
▹ By leaving the two Return jacks unused you can use the pedal as a 2-way splitter, taking two equal outputs from SNDA & SNDB
▹ By leaving the Send jacks unused you can use the pedal as a mixer. Just connect the two signals that you want to mix in the RTNA & RTNB jack. In this case you can also use the Pan control.
▹ Voltage Required: DC 9-24 Volt / Polarity: Negative tip
▹ Max Current draw: 14mA (@ 9V)
▹ Input & Return Impedance: 10MΩ
▹ Output & Send Impedance: 100Ω
▹ All loops have common ground